Settings on 1970 Evans FET-500 Custom?
Moderator: Dave Mudgett
-
Riggs Horton
- Posts: 16
- Joined: 31 Jan 2025 5:50 am
- Location: Tennessee, USA
- State/Province: Tennessee
- Country: United States
Settings on 1970 Evans FET-500 Custom?
I just got this for my first Steel amp, it sounds so wonderful, but I was curious about a few of the settings. The first was the three way switch next in between the Bite and Reverb settings, and the other is the sensitivity control in the back, I am currently not certain what either of those do. I also wondered what the bite and expanded Switch do. Thank you for your help!
You do not have the required permissions to view the files attached to this post.
Riggs Horton
-
Riggs Horton
- Posts: 16
- Joined: 31 Jan 2025 5:50 am
- Location: Tennessee, USA
- State/Province: Tennessee
- Country: United States
Re: Settings on 1970 Evans FET-500 Custom?
Here’s a close up of the 3 way switch
You do not have the required permissions to view the files attached to this post.
Riggs Horton
-
Glenn Stanfield
- Posts: 33
- Joined: 3 Feb 2026 10:56 am
- Location: El Paso
- State/Province: Texas
- Country: United States
Re: Settings on 1970 Evans FET-500 Custom?
EvansAmps is still in business. You might reach out to them to see if they have a manual available.
Their current amps have a 3 way switch for the reverb that selects Reverb Only, Reverb+Flanger, or Reverb+Chorus.
Their current amps have a 3 way switch for the reverb that selects Reverb Only, Reverb+Flanger, or Reverb+Chorus.
GlennS